Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is the difference between 'nvram' and 'manual' in below output .Interface IP-Address Method Status ProtocolGigabitEthernet0/1 X.X.X.X NVRAM up upSerial0/0/...
Hi Experts,I am seeing bursty errors and slip secs in my serial interface..T1 circuit is connected to it.. I checked with ISP and they dont see any issues from their side and we have checked the local cable between deamrc and router, no issues seen.D...
Please find the output below,Serial0/0/0 is up, line protocol is up Hardware is GT96K with integrated T1 CSU/DSU Description: MPLS WAN TO PE ROUTER Internet address is 68.176.92.26/30 MTU 1500 bytes, BW 1544 Kbit/sec, DLY 20000 usec, reliabil...
started facing issue with this circuit in recent time.. Here is the clock settings Network Clock Configuration --------------------------- Priority Clock Source Clock State Clock Type 10 Backplane GOOD PLL ...
Here is the network clock output. Network Clock Configuration --------------------------- Priority Clock Source Clock State Clock Type 10 Backplane GOOD PLL Current Primary Clock Source -------------------...
