Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have following QOS requirementsClass 1 EF 41% bw > LLC Queue (implemented with the priority command, not priority percent)Class 2a AF31 30% bw > bandwidth percent 30Class 2bAF41 20% bw > bandwidth percent 20Class 3 best effort (remaining) Link ...
helloip audit protected [ip address - ip address] according to cco it defines a protected address space for IDS, this is from cisco.An attack signature detects attacks attempted into the protected network, such as denial-of-service attempts or the ex...
Hello folksi just notice that the distribute-list command is not avalible in isis. What would be the best solution to get rid of a certain route in isis ?
i am running in to bug, i thinki habe a hub&spoke NBMA network with 1 Hub and 3 Spokes2 spokes receive all routes and work find but 1 router get LSA into Database but can't install those routes into the rouring table.i debug ip ospf spf and the failu...
something to add to provide more information On the core router, i connect severeal PE routers with 1G links. The agregated bw of all PE class 1 traffic could overload the total amount of reserved bw for Class 1 on that core boxThis is a design quest...
thanks but unfortunately its still not clear for me. If no addresses are defined as protected, then all addresses are considered outside the protected network. may i should phrase my question a little bit differentIf i am not configuring that command...
hi pareshthanks a lot, you confirmed my assumtions. I was just wondering because in ospf this command is available. In my case i dont care if all my router have the unwanted prefix in the database, if i have the oppurtunity to filter it out between t...
its NBMA configured because enc. is frame-relayhere's the hub configinterface Serial0/0 no ip address encapsulation frame-relay no frame-relay inverse-arp frame-relay lmi-type cisco!interface Serial0/0.1 multipoint ip address 192.168.1.6 255.255.255....
its really funny i just reload again and the problem appears again.here's what you ask fowg1r3#sh ip osp da OSPF Router with ID (11.22.3.3) (Process ID 1) Router Link States (Area 1)Link ID ADV Router Age ...
