Hi Jon Configuration is part of the IRD manual. For assistance or missing documentation you can open a TAC service request.

Hi Emin, You will need to configure the multicast joins on your DCM to define what sources you need.Of course you will also need to configure your router ports to enable multicast, configure PIM ...When using unicast, you just need to stream your fee...

Hi Emin, the complete configuration guide is available on the DCM. Go to help/manuals on the GUI.If you have issues during configuration, don t hesitate to open a service request. TAC will assist you.

Hi Emin, Bot multicast and unicast can be used on the DCM output and input. You also have the possibility to use UDP or RTP.Hope this answers your question.

Hello, The best thing to do is to open a service request with cisco TAC and allready gather the logs including the HW statistics from the device. Cisco TAC will verify the status of the card and start the RMA process if needed.