Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello-I have multiple routers which run multiple VRFs of which I thought were configured for external access from our public VPN NAT but, on losing access to a site that was still technically online, we noticed we could not connect externally. It see...
Hello there-I've had a provider switch from dedicated /29 with static upstream routing to PPPoE with the insistence that we don't now have a next hop. There's a huge language barrier between me and the provider so I need to go through an intermediary...
So I'm not quite sure what's wrong here. I have a switch which runs two VLANs, one trusted (50), one untrusted (55) and has ports dedicated to each. Both VLANs use a single DHCP server, homed on the trusted (50) VLAN. On my wireless setup this works ...
I am trying to join my 1130AG-E-K9 AP to my 2016 WLC, but it is stuck in a boot loop and will not connect to the controller. The error I'm getting is:*Mar 1 00:00:29.584: %CAPWAP-3-ERRORLOG: Could Not resolve CISCO-CAPWAP-CONTROLLER*Mar 1 00:00:29....
Ok, in the end it turned out I needed to configure the PPPoE config on Dialer1 and then call it out as an 'unnumbered' interface, with the IP/subnet living on the physical external interface, Gi8: interface Dialer1
mtu 1492
ip unnumbered GigabitEth...
I'm not clear if I'm missing something from the provider, but I have the following:
-PPPoE username/password-/29 for me to assign as my WAN IP
Removing Dialer1 and the PPPoE config will fail to have this connect and, as I don't have a next hop, I...
Yes, the config was working perfectly (DMVPN, external ssh access, NAT, tunnels, ZBF, etc) until the provider changed their circuit delivery. Again, in the past we had a /29 with a gateway defined, now they've given us a PPPoE config with no gateway ...
Indeed, am running a ZBF, with DMVPN for access back to the rest of our network. No VRFs and DMVPN running on Tunnel100. Rough config here: interface Tunnel100
tunnel source GigabitEthernet8
interface ATM0
no ip address
shutdown
no atm ilmi-keepa...
