Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello- I am looking at installing two N7K-F132XP-15 line cards, one in each of our N7K VPC peer switches. I have reviewed Cisco Hardware Installation Guide and it appears as though, with some common sense regarding static elecricity, the cards can b...
Hello everyone-I have an ASA-5585-SSP-10 that I have subinterfaces and VLANs created on. I used this ASA to firewall the vlans downstream on our Catalyst 4k's. Most all of my interfaces have specific ACLs in for the necessary traffic and all is good....
Hello everyone-I'm hoping someone can give me some assistance on a task I'm trying to accomplish with remote access VPN on an ASA5510. I am looking to configure remote VPN for 2 of our business partners. Each partner will need access to varying locat...
Hello, I am attempting an IOS upgrade on my Cat4k's. I've got two 4510R+E switches. I'm upgrading from 3.2.1.SG to 3.4.2.SG. As you can see below I've got 3.4.2 downloaded and stored in flash. The next step is to set the boot variable and reload. The...
Good morning all-I am working on an ASA 5510, running version 8.4. I am attempting something which I imagine would be straight forward, but having some issues.I am configuring connection profiles for both client and clientless VPN on the ASA. I would...
Jouni-How would you recommend I allow Intenet access outbound using ACLs in the ASA, without the any-any. We do not proxy to our web filter appliance, we have a Juniper firewall (external) which redirects 80 and 443 traffic to the web filter, it then...
Marvin-You got it. Once I saved the running config the correct boot variable is shown. I don't recall having to write the config on older platforms, the value would update immediately?Thank you Sir!
Hey Leo-I have yes, with "no boot system flash bootflash:cat4500e-universalk9.SPA.03.02.01.SG.150-2.SG1The command takes, but doesn't change the output of the "show bootvar", still displays 3.2.1
Jose-One other question, if I were to send external clients in through https://remote.domain.com/access and keep all internal employees at https://remote.domain.com, how would I prevent external clients from logging in to the specific profiles if the...
