Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,What you need to do is to implement RMON so that you can get events related to interfaces flapping.I assume you have callhome configured at present which allows you to get notified in case of critical system events.The following link will help ...
Hello,Only the switch that is directly connected to the NPV enabled switches needs to be enabled for NPIV. NPIV provides a means to assign multiple FC IDs to a single N port which in this case would only be done on a single core MDS 9513 Director. ...
Girish,If you are looking for a non-disruptive upgrade path, I would suggest you upgrade to 3.3.x first. This is also discussed in the release notes which can be found here: http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/4_1/release/...
Hello,The following link will take you to the download section for MDS Firmware:http://www.cisco.com/kobayashi/sw-center/sw-stornet.shtmlYou would need to login using CCO username/password.Hope this helps.Regards,Nikhil
Mike,It should be the same configuration on both sides for the port-channel to come up. The reason why you can assign a port-channel to a VSAN is that if you are using an E port then it depends on the matching port-channel VSAN to come up.TE Port fu...
