Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I have been using the following network topology to test OSPF, configurations are also attached.
In this setup R2 and R3 are both ABR's connecting to Area 0 and Area 1 respectively. R2 is also an ASBR due to redistribution of BGP into OSPF...
Hi All,Please see diagram attached, I have a scenario where i have dual CE-PE configuration and need to enable mutual redistribution between BGP and OSPF. My concern is with routes being redistributed into OSPF from BGP and being re-advertised/redist...
Hi All,I have a query regarding per module load balancing using a Layer 2 Etherchannel.I have two modules in a 6509, using per module load balancing, I have one card set to source-ip hashing, and the other card using destination-ip hashing. My questi...
Hi All,Can someone please clarify the "show vlan internal usage" command on a catalyst 6500.I have read some docs on the web but i'm still a little unclear as to what vlans are clasified as internal usage?Can someone give me a explanation around this...
Hi Julio,
Thanks for the reply.
When I check the border routers I can see both R2 and R3 as expected:
R1#show ip ospf border-routers
OSPF Process 1 internal Routing Table
Codes: i - Intra-area route, I - Inter-area route
i 2.2.2.2 [10] via 192....
Thankyou for your responses they have been very useful!In this scenario where BGP routes are being redistributed into the OSPF IGP I guess this removes the need for an iBGP connection between the CE routers as both CE's will learn routes via OSPF?Reg...
Many thanks for your responses,As I'm dealing with a very large routing table it would not be practical in this instance to use the network command, but certainly this would have been preferred.In the case of routes from OSPF being redistributed into...
