About kris-andrews

kris-andrews · 11-03-2017

Hi All, I have been using the following network topology to test OSPF, configurations are also attached. In this setup R2 and R3 are both ABR's connecting to Area 0 and Area 1 respectively. R2 is also an ASBR due to redistribution of BGP into OSPF...

kris-andrews · 08-18-2011

Hi All,Please see diagram attached, I have a scenario where i have dual CE-PE configuration and need to enable mutual redistribution between BGP and OSPF. My concern is with routes being redistributed into OSPF from BGP and being re-advertised/redist...

kris-andrews · 01-20-2011

Hi All,Can someone please clarify the difference between 10Gbps LAN Phy and WAN Phy?Is there is a preference between using either/or?

kris-andrews · 12-09-2010

Hi All,I have a query regarding per module load balancing using a Layer 2 Etherchannel.I have two modules in a 6509, using per module load balancing, I have one card set to source-ip hashing, and the other card using destination-ip hashing. My questi...

kris-andrews · 12-02-2010

Hi All,Can someone please clarify the "show vlan internal usage" command on a catalyst 6500.I have read some docs on the web but i'm still a little unclear as to what vlans are clasified as internal usage?Can someone give me a explanation around this...

kris-andrews · 11-06-2017

Hi Meheretab.Many thanks for the explanation! it makes a lot of sense to me now.ThanksKris

kris-andrews · 11-04-2017

Hi Julio, Thanks for the reply. When I check the border routers I can see both R2 and R3 as expected: R1#show ip ospf border-routers OSPF Process 1 internal Routing Table Codes: i - Intra-area route, I - Inter-area route i 2.2.2.2 [10] via 192....

kris-andrews · 11-04-2017

Hi Meheretab, Thanks for the reply, I have attached the routing tables of each router and also the OSPF database router LSA outputs. Thanks Kris

kris-andrews · 09-13-2011

Thankyou for your responses they have been very useful!In this scenario where BGP routes are being redistributed into the OSPF IGP I guess this removes the need for an iBGP connection between the CE routers as both CE's will learn routes via OSPF?Reg...

kris-andrews · 08-19-2011

Many thanks for your responses,As I'm dealing with a very large routing table it would not be practical in this instance to use the network command, but certainly this would have been preferred.In the case of routes from OSPF being redistributed into...

Member Since	‎04-04-2008 02:26 AM
Date Last Visited	‎11-06-2017 04:41 AM
Posts	35

User Statistics

User Activity

OSPF Type 4 LSA - Dual ABR

Mutual Redistribution BGP<>OSPF

LAN Phy or WAN Phy?

Etherchannel - per-module load balancing

Vlan Internal Usage

Re: OSPF Type 4 LSA - Dual ABR

Re: OSPF Type 4 LSA - Dual ABR

Re: OSPF Type 4 LSA - Dual ABR

Mutual Redistribution BGP<>OSPF

Mutual Redistribution BGP<>OSPF