Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup router to router with a pix in between but am having nat difficulties, see attachment for design and address. I am trying to use Dynamic Multipoint IPSECPartial Configs:Router Acrypto isakmp policy 1 encr 3des hash md5 authentic...
I am adding an Eth card to our existing Cat4500 w/ Sup IV, can I add this card hot? Or are eth cards just hotswap since the card needs to be present on ios bootup?Thanks!
I am trying to determine the wep key in one of my profiles, but of course the Client Utility greys it out. Anyone know which file or registry key it is stored in? and if you can read it through notepad?Thanks!
I have been using a 2950XL w/ 2 VLANS for some time on our DMZ (one VLAN for outside and one for the DMZ)and just purchased a new 2950 because a couple of the ports on the 2900XL died... I had it set up before for port fa0/1 to be the span port for p...
Some of our sites have dual PVCs pointing to two different FR T1's on our head-end router, the PVC's have the same port speed, CIR, and the bandwidth command is set to the same for both PVC's, so from EIGRP the paths are equal. My question is how do...
Gabriel,On your VPN headend router, enter your transform set comand then add 'mode transport', ie if your transform-set looks like this:crypto ipsec transform-set asis2saes esp-aes 256 esp-sha-hmacthen add: mode transport on the next linemode transpo...
Here is the output of sh sysopt and sh fixup, the attached txt has the output of deb crypto isakmp from Router A:PIXAKR01a(config)# sh sysoptno sysopt connection timewaitsysopt connection tcpmss 1380sysopt connection tcpmss minimum 0no sysopt nodnsal...
Actually, there is no 'rtr2' If you would replace rtr2 with a frame cloud then that is how it looks like. rtr1 and rtr3 are 'directly connected'.I am looking at the CEF info from rtr1. Per packet is just turned on only the serial interfaces.I did f...
Here is what the traffic flow looks like: 22.0 -> fa0/0 -> s0/0.4 or s0/1.4 -FR- -> s0/0.1 or s0/0.2 -> fa0/0 -> 141.0141.0 is the remote LAN subnet, 22.0 is our data center subnet. Right now 'ip load-sharing per-packet' is enabled o...
That is what I thought the current path meant... However on all of the interfaces that I have CEF per-packet enabled on it always shows that the serial 0/0.x is the 'current path'. Here is a copy of what the config looks likeinterface Serial0/0.4 p...
