Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I'm currently stuck with an issue with DHCP relay not working on cisco FTD over site-to-site VPN and hoping you can assist. I have a setup which looks like this. LAN---->FTD1 --->VPN-->>FTD2-->CORE--> DHCP subnet. FTD1 is configured f...
Hello,
Looking for a little assistance troubleshooting MPLS vpn over MGRE.
I cannot share configs or topology as it is confidential information. I can't even remove the config from site. I have MPLS VPN over mGRE running in a lab environment at ...
Ok, so my issue was because I'm an idiot :). I fat fingered one of my network objects which had an impact on my access policies, NAT, and interesting traffic for the VPN. Thanks for the quick reply.
Hello, One way you can manage your device over the VPN is to route the management interface on another device such as a core switch. something like.site A ---VPN---siteB--Core(L3 device) ---FTD management interface.Then you can manage it as a host at...
Luck!! I used ctrl-z and exit depending on the mood i'm in lol. It just happened that I was working on 2 different nexus environemnt. One work and the other didn't. The only difference was that I used ctrl-z rather than exit, lol. Just a stroke of lu...
This was the weirdest thing. not sure if you fixed your problem but it wouldn't work for me until i hit Ctrl z after the config. Only ctrl Z worked, I still had the same issue when I typed "exit". It would always show "this server is temporarily unre...
