Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have created tunnel interface 3101 with source interface as Dialer 1 , now the tun 3101 is showing output drops while the dialer is clean.I have tried to clear counters on tun 3101 but no use....can you please suggest what could be the reason for t...
Hi all,I am currently facing an interseting issue and it goes like this.....We have one URL hosted on of the server which is access by both our private domain ( intranet domain) and public domain (internet domain).For intranet users we have simply al...
Dear All,I am trying to create remote access VPN in pix 535 through ASDM , but i am unable to do so.I have done all the required config ( creating group policies, creating client address pool nat exempt this ip with my internal ip , acl , and bindin...
Hi all,Currently i am having two radware Web Server Director Pro AS, Cookie Persistency (512 farms).While configuring VRRP through APsolute insite we got an error while copying configuration from master to backup.Kindly suggest the solution to proce...
Hi All,We are planning to use two CSS 11506 devices in the Box-Box redundancy method as per our design requirement.We suspect that the failover does not work if the primary loadbalancer fails and active pixfirewall is still up.as the pix fails to upd...
Hi,Below which is marked red is actually internet and not intranet sorry for the typo errorbelow are the answers of your question..Q- So you are saying the inside hosts are able to reach the webserver using its internal address but, the internet use...
There already few user who are using their VPN . However for one specific user i am unable to create remote access vpnconfig done on firewall is lanuser_nat0_outbound extended permit ip host 10.14.0.100 172.25.21.0 255.255.255.252 !access-list rsudhi...
Thanks for the information.Can you suggest me the version of APsolute insite which is in accordanve with WSDCurrent Version is :WSD IOS Version is 8.16.13APsolute version is 2.70.17DL
hi,Thanks for your reply....Switch is already interconnected ( sorry for the wrong diag)But my concern is if When we configure reduandancy of CSS in VRRP mode and in case CSS 1 fails and CSS 2 becomes active its VIP will be same with different mac -i...
please refer to the document attached ...between firewalls and CSS we have 2 switch , but then too we suspect whetherfailover will happen if css fails and primary pix is still up if we go to BOX to box reduandancy.
