Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi all,Is it possible to monitor via SNMP the MSE (7.4 and newer)? I.e: can I configure a notification receiver which receives some traps (port 162) and is informed about the status/health of the device?I was thinking of:- hardware status- HA status ...
Hi allI have a correctly working HA pair of 5508’s. This means:- LAG enabled (two different port channels on two different switches).- Dynamic VLAN’s faced to SSID’s (VLAN30,VLAN40) are carried to both LAGs.- Same VLAN of Mgt Interface and redundant ...
Hi everybody.Two 5508 WLCs running 7.4.100.60. I had to activate HAI decided to configure Service ports: following HA conf guide, I used DHCP. That's because static IPs on service ports are often cleared and forgot during switchove...
Hi,
the correct doc to look at http://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn81mr2.html#pgfId-1319021.
It is dated Augost 2017.
Maybe it should be supported in 2019, but it is only a hope.
Hi
Hi Nabeel,I have the same problem. I opened a TAC case, where Cisco said "the host move should not be causing the issue in the HA". As far as I am experiencing, this is not true. I am testing in may lab, too: after I installed the two VM connected vi...
thanksWhen I installed the WLC, I had Apple TVs and clients on the same VLAN/WLAN. I activated multicast on WLC and ALSO on the L3 switch connected to the WLC. Everything worked perfectly.Now I am asked to send Apple TV service on different VLANs, an...
Sincerly speaking, I don't know why decibels are so difficult to be known.Once again:Signal is measured in dBm (or Watt, or milliwatt, or boiler horsepower)dB are used to indicate ANY ratio: x dB = 10 * Log a / b.If you have doubled your incomes, you...
