Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, when detaching a cable from a BaseT port there is a certain delay before the "interface down" message shows up in the log . Does this explain with the fact that according to IEEE standards the "interface down" status for BaseT interfaces is ...
Hi All, I am dealing with the following issue: I need to load balance a custom developped application that works like this: a session on port tcp1315 is opened on the server and closed, after that a classic ftp session is started. All this works fine...
Hi All, I have a simple topology made of a couple of Cat6500 switches (native IOS) connected between them and to a Cat3750 (stack of two). I have MST running. When adding a new Vlan it gets propagated to all the switches via VTP, when I assign it to...
This is the scenario: two Cisco1751 routers with voice ports connected by a point-to-point ADSL line. Configuring QoS with fragmentation and Interleaving results in packets bigger than the specified fragment-size not going through the line (i.e. if ...
Hello Giuseppe, thank you for your answer, my question though was a little different, I'll try to make myself clearer . Let's say the event is "I missed some keepalives in a row" and this happens at T0: Is the "interface down" message displayed at T0...
Hi François, last night we further investigated the issue. First of all: the problem observed last week was caused by malfunctioning a 10G card. After replacing (better said, restarting) the card and verifying that it was functioning properly we cre...
Hi François,thanks for your answer. The IOS version we are running are not that old. We have the following IOS files running : s72033-adventerprisek9_wan-vz.122-33.SXH.bin on the two Cat6k and c3750e-universalk9-mz.122-35.SE2.bin on the Cat3750E.We ...
Thank you for your answer, I had already had a look at that webpage and configured the routers accordingly using a virtual-template for Multilink PPP. The impression is that with fragmentation configured the router does not fragment at all....
