Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Does anyone have a procedure for exporting the PVK file from an ACS 1113 appliance?I am trying to replace my ACS hardware and want to avoid getting a new certificate issued as it is a long and painful process Any assistance is much appreciated...
Hello,I would like to use WCCP to enable dynamic redundancy between Web proxies located in two data centers separated by an L3 link.Is this possible?Thanks in advance,Ade
Hello,I need to configure my CSM 3.2.1 server to act as a syslog collector for my ASA firewalls. I noticed that installing CSM automatically installs the CiscoWorks syslog service but I have been unable to find where I can configure the service.I ha...
Hello everyone,I am aware that this question has been asked in several formats before. I have read through some of the previous postings and the documentation as well. However, since I am new to this, I thought it best to submit a new posting.I hav...
Hello everyone,I am currently working on an installation in an environment with heterogeneous fiber patch panels (50 and 62.5-micron cabling) that I would like to use for switch interconnects. Currently, the 62.5-micron connections are all in use an...
That is my exact problem. I can not pin the VLAN to the User ID since there is no way to predetermine how many users belong to a group. There are over 5000 users in AD. The VLANs have always been assigned based on location (not department or OU) an...
Hello guys,I apologize for jumping in but I did not want to start a separate thread as this is also a question about 802.1x and EAP on a wired LAN.My issue is slightly different.....I already use PEAP for my Wireless LAN and want it to my wired users...
Thought about that too......unfortunately, the budget does not allow me to double up on hardware.The key here is that I also have to consider DC redundancy as the network has quite a few remote sites. So my ideal choice will achieve both hardware an...
Thanks for the clarification. Using a layer 7 switch (load balancer) will introduce another point of failure. Due to the fact that there is a layer 3 connection between DCs, I will not be able to cluster the LBs.....giving me another component to w...
Hello Dan,I thought this (your concept) would be fine as well but the WCCP configuration guide for the Catalyst 4500 switch states that the cache engines should not be separated by a Layer 3 hop. That's the part that confuses me.http://www.cisco.com...
