Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I upgraded my CSACS 1121 from ACS 5.1 to 5.2 following exactly the official upgrade guides. 1st step:Backing-up the acs-config using the CLI cmd "acs backup filename repository tftp_server" (filename on TFTP server = acs_hau_02_20101005-101005-0810....
I have an installed base of ACS 5.1 and MS AD. Some users are allowed to dial-in via VPN based on the attribute "msNPAllowDialin=True" within AD while others have no permission.Whenever ACS send an LDAP-request to AD to retrieve the attributes it get...
Hi Frederico,many thanks for replying to my question. The output of "show mac address-table int gi0/45" and "show authentication session int gi0/45" are as follows:Vlan Mac Address Type Ports---- ----------- -------- -----...
Hello Bastien,many thanks again for your reply. I did already traces using Wireshark. It was exactly the same client, who sometimes got an IP address and sometimes not.If it does not work - I clearly see that the client send DHCPDISCOVERS but never g...
Hello Bastien,obvoiusly we have some kind of misunderstanding. You're absolutely correct: PXE does not support 802.1x. My goal is to bring a new client (which has never been connected to our netwok before) to the quarantine VLAN, where it shuld get a...
