Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have CUCM 8.6 and a H.323 gateway with VIC2-2BRI-NT/TE.I'm thinking about connecting ISDN phones to the CUCM using the VIC2 in NT mode.I was looking for configuration examples but didn't found anything usable...Any hints ?
I moved my residential PPPoE termination point from a 876 router to an ASA 5505 running version 8.4(1).Everything is ok beside IPv6...At IPv4 through IPCP I get the interface address assigned and the relative default-route being set.At IPv6 nothing h...
My workaroud for this is to use the 876 as PPPoE termination point in front of the ASA and route traffic.IPv6 is simply routed between the ISP and the Outside (Static Addressing) interface of the ASA.For IPv4 I use NAT both on the 876 and the ASA, wi...
I wouldn't install any CU on non supported hardware for productive systems but it's just fine for lab purposes. There is a way to install directly to AMD ESXi which involve editing a file in the ISO image of the installation disk (to remove the hard...
Routing to an interface on IPv6 is not a good idea (due to the nature of the protocol).You could use a route to the next-hop but usually ISPs tend to use link-local on virtual interfaces at the DSLAM side and those interfaces have the tendence to ren...
