About kmaher

kmaher · 11-15-2008

Hello,I am currently trying to set up a pair of FWSMs on 2 peered 6509s as a failover (active/standby) pair.The 2 chassis have a ten gig link trunked between them with 3 VLANs on the trunk - outside (which routes to the MSFC on the 6509), state, and ...

kmaher · 02-08-2019

I was also just looking for that device. The FP stencil set has not been updated since Jun of 2016! ASR stencil set since '13. Seriously... it's hard to produce good rack elevation diagrams if we don't have a good stencil to work with.

kmaher · 04-02-2013

Why not use route reflection and get rid of the EIGRP? I was running into this same issue with a router cluster. I had EIGRP for v4 and RIPv6 running along side BGP. RIP was creating a loop that I simply could not figure out.So, I have redesigned ...

kmaher · 06-13-2011

We too are on NCM 1.6 and have memory issues. However, our server is 64-bit. I cannot yet find anything about where to increase the internal allocation. We have 16BG on our host, yet NCM seems dead set on only using a fraction of it. I disabled t...

kmaher · 11-15-2008

Well, looks like something rather simple. A coworker reviewed the troubleshooting doc. It turns out that our inside interfaces (which are all layer 2 ports on the 6509) must be set up on the trunk between the 2 6509s. It can not rely on the layer 2...

Member Since	‎10-19-2004 05:17 AM
Date Last Visited	‎02-15-2019 01:14 PM
Posts	6

User Statistics

User Activity

FWSM sync failure

Re: Visio Stensils FPR2100 ?

Re: iBGP routes not getting redistributed into EIGRP

Re: NCM

Re: FWSM sync failure