Hi all,   unfortunately the error reoccured. I opened a TAC case. We are hitting that defect:   https://bst.cloudapps.cisco.com/bugsearch/bug/CSCva18879/?reffering_site=dumpcr   The work is still in progress, they adviced me to to reconsider my config or take away any jabber softphone...   Paul ... View more

Hi,   I was able to reproduce the error. But at least I still do not know why the issue occurs... If I reset the Hunt List I need to register some Jabber Softphones again. So I put all line in one Line Group. If I added or removed a device I wasn't able to reproduce the issue. So I hope the issue won't occure now. ... View more

Hi, I know the thread is old but I like to understand. Here I could say, yes my ACL blocks clinet UDP high src port to CUCM 4000 dst port. Why the client sends if it is MoH?   Paul ... View more

Hi,   we found a solution, but not the reason. We found out that the HP with some Lines with just one phone works as expected. If we added a Line with more devices (CSF,BOT,TAB) which were not registered for some time the issue reoccured. Then we tried to connect each of that devices and after that the HP works as expected for that Line, too. We were able to disconnect some of that devices and it works, we configured some of that disconnected devices as "Logged into Hunt Group" and it works. Now we try to contact each user, that should be part of that HP and ask him to connect each of its devices :(   But at least we do not know why the issue occurs. Is it a phone config corpse? When will it reoccur... We like to use it for our Hotline. We do not have a good feeling with that situation.   Paul   ... View more

Same here,   any one found a solution? Strangly it works in my Test UCM Cluster... Did a cluster restart helped out?   Paul ... View more

Thanks a lot for that advice. I am focused on 15.6(2)T because of support for SIP Session-ID. Will that feature ( Variable length Checkpointing Enhancements for enhanced HA in CUBE) also be included? ... View more

Hi, thanks for your reply. I uploaded the logs to the owncloud foulder I sent you.   Paul ... View more

Hi @Jaime Valencia,   it works for me too if I set Do Not Disturb on my Jabber CSF device. Then my deskphone and my BOT are set to DND but not my DX80... I do not know why, but after I did it on my CSF Jabber, I am able to set DND on my Jabber which controls my deskphone via CTI and it also set my phone and all other die DND. Now it works like you wrote. From Jabber I can set it to all devices but not from deskphone. There are any plans make it possible from deskphone?   Best Regards Paul   ... View more

We are using a DSPfarm but with "associate application CUBE" Yes you are right it seems to work good but I am just concerned about the logs.   Paul ... View more

Hi @Jaime Valencia   thanks for your fast response. There is a depending configuration to be able to set Do Not Disturb from jabber to associated device? It is controlled via CTI.   Paul ... View more