In the new version 5.2.2 DMM it now reports the LCD status.I have a Cisco 40" that show that it is OFF when it is on.Is there a procedure to get the status to display proper state?Thanks.
Michael,We have about 165 signage players across a campus of 19,000 students in multiple buildings and a remote campus.Industry Weapon is a Great product for running Emergency alerts and to corectly format the content from our department's to run w...
Michael.I have tried a ELO 4600L Part Number# E960985 Inteletouch display with the dmp4400.After Telling DMP it has a touch display it acts pretty much like a mouse.Load a web page in the dmp and you can click around.Currently we are using Indus...
Try A Hard Reset, Hold Reset Button for 20seconds ( Two Beeps).( *Warning:Clears all settings*)Will have to setup from Defalt password.Then try upgrade.We had several not upgrade untill trying .It would act like it was burning upgrade and fail at Ve...
I have found a low cost off air receiver HD Home Run Tech.The base unit is 2 receivers for about $300.00Down side it dosn't let you chance the stream size of the decoded HD signal it can be quite large.It is a little hard to setup with script file.ht...
I have been using the 9pin to mini 3.5mm that is included with the DMP4310 on the DMP4400 to conect to the ME46 & ME55 Samsung. The pin out is in the Cisco Stadium Vision PDF on page 100.http://www.cisco.com/en/US/docs/Sports_Entertainment/StadiumVis...
