Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In the new version 5.2.2 DMM it now reports the LCD status.I have a Cisco 40" that show that it is OFF when it is on.Is there a procedure to get the status to display proper state?Thanks.
Michael,We have about 165 signage players across a campus of 19,000 students in multiple buildings and a remote campus.Industry Weapon is a Great product for running Emergency alerts and to corectly format the content from our department's to run w...
Michael.I have tried a ELO 4600L Part Number# E960985 Inteletouch display with the dmp4400.After Telling DMP it has a touch display it acts pretty much like a mouse.Load a web page in the dmp and you can click around.Currently we are using Indus...
Try A Hard Reset, Hold Reset Button for 20seconds ( Two Beeps).( *Warning:Clears all settings*)Will have to setup from Defalt password.Then try upgrade.We had several not upgrade untill trying .It would act like it was burning upgrade and fail at Ve...
I have found a low cost off air receiver HD Home Run Tech.The base unit is 2 receivers for about $300.00Down side it dosn't let you chance the stream size of the decoded HD signal it can be quite large.It is a little hard to setup with script file.ht...
I have been using the 9pin to mini 3.5mm that is included with the DMP4310 on the DMP4400 to conect to the ME46 & ME55 Samsung. The pin out is in the Cisco Stadium Vision PDF on page 100.http://www.cisco.com/en/US/docs/Sports_Entertainment/StadiumVis...
