Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm tryin to rebuild our VPN environment with a pair of 5520. WE're going to use Anyconnect mobility exclusively with SSL. No IPSec and no SSL Webvpn.We have a large number of contractors using the VPN to access specific internal resources so I would...
I have a pair of circuits from a vendor to our MPLS cloud.The primary is a straight MPLS circuit at 1GbThe secondary is now being provided on the vendors next generation network with includes local routing within the metro area.They are provided to s...
I have an issue in our environement at the moment with our OSPF setup.We have 2 edge routers with GRe over IPSec tunnels out to several remote sites. These routers are connected via our core router.Each of the remote sites have 2 tunnels configured, ...
I saw this problem between our WLC 8510 and our NX5596. The wireless lan controller default CDP version is version 1 and the default Nexus cdp version is 2. The WLC has an option to change the cdp version to V2 after this change we no longer had the ...
Turns out the solution was pretty simple. Keepalives were not set on the tunnel interfaces so they would stay up even when unable to connect.Turning on keep alives means the router with the disconnected tunnel does not try to route through it's local...
