Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to send a technician to a decomissioned remote site with no wan connectivity to clear the configs on a Cisco 871 router and 2950 switch. Is there a button sequence to press to permanently clear the config without requiring console access? Th...
With the latest CSM 4.2(10) code I've noticed that after initiating a config sync from the active CSM it takes approximately 30 secs for the standby CSM to register the configuration download status as 'PENDING'. CSM code prior to 4.2(10) would regi...
Does 6.0(4)E1 support password encryption such as for user-profiles and auto update accounts? I don't see it referenced in the documentation but just wanted to confirm. I feel this is a must have feature for a security device. Thank you in advance...
As of yesterday I'm no longer able to download signature updates and the following message is returned:"This page is only available to registered Cisco.com users with a Cisco Service Agreement."Our service agreement is still valid. The other questio...
As an example, what I'm trying to accomplish is to prevent two hosts on the same subnet from pinging each other. I prefer to use VACL due to hardware filtering performance and the ability to ACL L2 (same subnet) and L3 traffic but the 2950 doesn't a...
The documentation is not very useful. I needed a straight forward way to wipe the configs permanently, per policy, without requiring console access since the technician is not network centric. As discovered, this is not possible on the 2950 and 871...
I appreciate the info but we're using 12.2(18)SXF train.Just to follow-up on the issue the config sync feature is sort of unpredictable with CSM code 4.2(10). I've had one instance where a config sync was initiated but it never actually occurred. A...
When I do a 'show configuration' from CLI or 'copy current-config ftp:' it shows the user-profile and auto update passwords in clear text. Do I have to enable something to encrypt or even mask out the passwords? We need this for configuration back...
After changing the outside IP address did you clear the translation of the old public IP to private IP?Trying doing:"clear xlate" or "clear xlate global ".
