Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,Here is the scenario:Source (Inside) : 10.0.1.5/24 NAT IP: 10.0.1.25/24 (from the same Inside network)Destination, learnt via outside: 192.168.1.32/24 (not directly connected ,three hops away from outside interface of FW)If I initiate a conne...
Hi Guys,While advertising network 0.0.0.0 0.0.0.0 in EIGRP on a Cisco ASA failover pair, got the error saying "ERROR: EIGRP cannot be enabled on failover interface". I am unable to configure failover interface as passive interface. Please guide me..I...
Packet tracer shows no problem. it hits the right NAT command (I tried using auto NAT as well) object network obj-192.168.1.32nat (outside,inside) static 10.0.1.25No drops in hte packet tracer. probably, we need to check by enabling proxy arp in insi...
It did not work...its 8.4(2)...sysopt noproxyarp inside is in running config. I did arp realtime capture on inside interface: output:arp who-has 10.0.1.25 tell 10.0.1.5
Thanks Jouni...per requirement, the source is not needed to be translated...Just a question out of curiosity, the firewall has proxy arp disabled on all interfaces (eg., sysopt noproxyarp inside). do we need to enable them ? once the destination is t...
