Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I'm running Catalyst 9800-40 WLAN Controller that was "managed" with Prime Infrastructure 3.10.In 2024 I started with Catalyst Center. Catalyst Center should manage the config from the WLAN-Controller, but obviously there is no option to impor...
Hi all,I am currently working with Cisco Catalyst Center 2.3.7.11 and have a question regarding the Configuration Archive feature. How can encrypted Configuration Archive files stored in an External SFTP Repository be decrypted outside Cisco Catalyst...
Hi all,
I am currently working with Cisco Catalyst Center 2.3.7.11 and have a question regarding the Configuration Archive feature.
How can encrypted Configuration Archive files stored in an External SFTP Repository be decrypted outside Cisco C...
Hello,I'm planning to build our now Core-system with 2 Chassis C9606R and to combine them with SVL (stackwise virtual link).The question ist, how many Supervisor Engines can be used in this constellation?In our actual core (C6807):2 chassis - 1 SUP f...
Hello, to check, if I can update our WLC to version 17.3.07 it is necessary to knowif there are AccessPoints with VID 06 or earlier / VID 07 or later.How can I find out which VIDs our AccessPoints have?I'm using WLC Catalyst 9800-40 v17.3.04c and Pri...
Hello to all that replied,thank you very much for your advices (especially with the memory leak in SVL mode on 9600 machines).Just to do an annotation to the post from Enes Simnica:The SUPs in 9606R will be placed in slot 3 and 4 only!For the new cha...
Hello Richard,thank you very much for your reply.> Why do you want to know the VID?Well, exactly because of Field Notice 72424The release notes of Version 17.3.7 it says:- Supported APs:- Cisco Catalyst 9115AX (I/E) Access Points- Cisco Catalyst 9117...
Hello marce1000,thanks for your reply.Is there a way to do this on 800+ AccessPoints without wasting so much time?For sure the Controller knows all data of every AP. Is there a way to read the databasefrom Catalyst 9800-40? Best regards
Hello Flavio,thanks for your reply.You are absolutely right. With this you can check the VID of a handful APs.I have to find this out for 800+ APs and it would be very helpful to do thisin a way that would not be time consuming.Maybe there is a way o...
