Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,current topology is build from 4 6500 switches connected in a ring topology. Using Portchannel (2x 10Gbit) links to connect left side top and bottom 6500's (DC1), 10 Gbit link to connect right side 6500's (DC2)Inbetween a 1 Gbit link is used to...
Hello,I have a location where I have 2 WAN links, but without a dynamic routing protocol in between. I want to implement a kind of hub to 2 spokes VPN. But the spokes will actualy be on one single ASA firewall, each spoke on a different interface. On...
Hello,I am confused on what is and is not possible on access-lists when using a route-map permit....Will this work? I am redistributing routes from OSPF to BGP but also vice versa from BGP to OSPF. In BGP I am using route-maps to prevent routes redis...
Hello,using a 6509 with a sup 720 PFC3C/MSFC3 I need to configure two ERSPAN source session, but in different vrf's and each to a different destinationsession and ERSPAN ID.I have got one source session running using a loopback (in vrf ABCDE) as orig...
Hello, I have an issue with RSPAN. It is possible to have 2 monitor source sessions each on a different switch through a single rspan vlan and one monitor destination on a third switch to a single port? All 3 switches are trunked together and transpo...
Ok, just found out : if two paths are equal costs, the port with the lowest port ID (prio and port number) will win. So it is a matter of trying to arrange a lowest port ID on the blocking path incase the primary path will loose a 1 Gbit link inside ...
Thanks Shailesh, Guiseppe,so I am correct in assuming that the origin ip address in the first vrf will not be reachable from within the second vrf?I will look into the route-target import/export. Perhaps another option to investigate is moving the to...
That is the idea indeed.I am trying to do the same on 3750, but one of the RSPAN sessions only shows the TX and not the RX though I have configured both.
