Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone experienced problems with the console connection to a PIX running version 6.3(1) freezing on them? I have two PIXs running 6.3(1) that will intermittently freeze the console connection on me.
I have a PIX with the following configuration:aaa-server TACACS+ protocol tacacs+aaa-server TACACS+ (inside) host 192.168.1.1 77777 timeout 5aaa-server RADIUS protocol radiusaaa-server RADIUS (inside) host 192.168.1.1 77777 timeout 10aaa-server LOCAL...
We have a CSS switch running 4.01 (Build 50). We are load-balancing connections to dual servers behind the CSS. When the service to one of the servers goes down/suspended then returns to active we don't get any new connections to that service, unle...
I have a pair of Catalyst 2950s that I want to use Private Edge Vlans on. I want to know if the Private Edge VLANs extend to switches in a cluster (for example can a protected port on one switch in a cluster talk to a protected port on a different ...
I am trying to get my PIX to NAT addresses from a DMZ interface out the outside interface. If I use a block of addresses from the subnet of my outside interface it will not NAT them. Here is my pertinent config info:ip address outside 10.1.116.2 25...
We have not resolved the issue. We tried upgrading to a newer IOS, but it did not correct the problem. We are currently reviewing our configuration to make sure that we have all the rules setup properly.
Marco,I believe you still need to translate your inside address using NAT or a static translation. You would probably want a static translation such as:static (inside,outside) 10.0.0.2 10.0.0.2 netmask 255.255.255.255See http://www.cisco.com/en/US/p...
