Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
During Planning a complex LAN refresh one question arrived about the behavior of splitted Ethernetchannels build in error. For example swapped two Ethernet Links, upper Tabelle as designed and configured, lower table physical implemented What kind o...
Just one little thing before looking around for spare
Officially not any of the various xxWIC generation support hotplugging or hotswapping
The official way is
Power down routeradd,swap or remove xxWICPower up router again
Beside is not official supp...
That's only partly correct you can truly mix Version 1 and Version 2 Kit in one stack If you stay on C9300L series, But if you try to include a C9300LM into a existing C9300L stack you have to use on all C9300LM Stack ports version 2 Kits, so for exa...
Just to highlight the difference between
C9300L-STACK-KIT, uses cable STACK-T3-... with push tab / sheet metal hooks, the included adapters accept only thoose cables with sheet metal hooks
C9300L-STACK-KIT2 uses cable STACK-T3A-... with thumb screws,...
Hi
you might need to used Policey based local ipv6 routing on your router, as if you send traffic with source ipv6 generated from ASSIGNED-PREFIX-Dialer2 prefix (ISP2) and routed via static or learned default route via Dialer1 (ISP1) you might not ...
Normal Operation, Keep Eth 2 on shutdown, Router Funktion (L3) between E0 and E1 and for Swiching (L2) behave like that on E0 there is a 5 port Switch attached but the uplink (5th.Port) acts as Uplink Interface that cannot be configured, so it has...
