Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm considering use some MR33 to found a mesh network, covering a place do not have wire ethernet access.——ethernet cable——RAP---MAP--MAP………………MAPI can see a description about the maximum mesh hop in the Mesh Deployment Guide (CVD)：There will be a th...
I'm planning to extend our WLAN for outdoor environment. due to the limited budget, I considering use some 2600e AP (mesh IOS) to achieve this goal.As we know, MESH using 5G for backhaul and 2.4G for client access. So it is possible to using a direc...
Since F series modules focus on providing high-density, low-latency local traffic forwarding, I don't think cisco will lunch a XL option for F series.If you need large table, deep queue…… M series would be your choices.
Unfortunately, when you add a switch to the exist stack, the new switch became part of the stack, all of it's config will not import to the exist stack, after the new switch provisioned you must merge the config manually.
