Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a working L2L between two locations. Location A and Location B.Location A: 172.16.16.0/24Location B: 192.168.0.0/24I would like to block anything inbound to Location A from Location B that isn't initiated from Location A. The block should be d...
I would like to send FTP traffic over our T1 line and all other traffic over a DSL connection. Our DSL connection is on F0/1 and our T1 is on Vlan1. Nat shows that ftp traffic is translated to the IP on Vlan1 but from there it appears that it doesn't...
Hi,I have a 2611 set up with NAT and the throughput is under 1mbit/s. Is this normal for this router? If I plug in my laptop directly to the WAN I get an 11-12mbit/s connection.Config:version 12.3service timestamps debug datetime msecservice timestam...
Hi,I have a Cisco 2811 and I was informed that all I needed to configure it with our DSL and our T1 was the router and a WIC-1DSU-T1-V2 card.Right now I have the DSL modem plugged into FastEthernet0/1 and our private network plugged into FastEthernet...
Thanks for the info Hubert. I was looking more at blocking all IP traffic incoming from location B though and only used SSH as an example to show that I wanted outbound connections to work (stateful).I did learn a lot about the filtering options from...
Not quite, but that does mean TAC is the best route. I'll contact them tomorrow (if they're open on Sundays). Thank you for letting me know what you did to get it fixed!
I'm having the same issue. Sometimes the connection will stay live for a little bit - longest was 90 minutes. But once the flapping starts, it is never ending. I have two routers (2901 and 1921) both experiencing this in two different geographic loca...
I found a solution to the speed issue. I dropped the E0/1 interface to half-duplex and the speed jumped to 4Mbit download. Then I switched E0/0 to half-duplex and the speed jumped up to 6Mbit+ which is close to the max the router will do according to...