Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have the 500S expansion cards and can't transfer to any extension beginning with *.So if we want to 1 touch transfer to a parking lot at *3103 we have to press bxfer and then the blf key..Wouldn't it be simpler to just enable this function to allo...
Phone is on 7.5.1 firmware with 500S expansion.We use an opensource pbx called Freeswitch. The blf works great for a couple of hours and then stops working especially if the phone has been idle for a little while. When the phone reboots, BLF resumes ...
We are on 7.5.1 firmware with a SPA504g and 500S attached. Normally when we are on a call, we can just hit the blf of the person we want to blind transfer to and this works great because we don't have to hit bxfer and then the person we want to trans...
I'm having this exact problem as well with voip especially. Someone from Cisco want to chime in here?I've tried rv082, rv042 and latest firmware on both. Still no dice. My steps to replicate are exactly as Roland mentioned above.
Thanks very much. This would make my life and the life of our customers so much easier. It is worth paying cisco for this for sure because it would save alot of support calls
