Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloWe use a Cisco 877 router with a Dialer Interface for Internet and FE Interface for our LAN.A few days ago we discovered that a specific website we access on a regular basis is not reachable from our office. However any network outside our offic...
Hello AllI am starting out new with RSVP and have read some documents on Cisco's website regarding the RSVP configuration. I have to say I still feel a bit lost with RSVP.Firstly a description of my network. I have a 6 site WAN. Every site has a VoIP...
Hello AllI have noticed a new interface on a cisco 7301 router. The interface is SSLVPN-VIF0. From the name it clearly says what it is, however I am still a bit confused about a few things.Is this automatically created by the VPN server or router? Is...
HiI have the following setup:LAN1 with DHCP server 10.20.30.253 & Internet server as gateway for LAN with IP 10.20.30.254. Both are on the same subnet.I have a remote site LAN2 which is getting DHCP from LAN1. That is working fine. However I need to ...
HelloI have a WAN with Cisco 1841 routers.RouterA FE0/0 10.20.10.42/30 FE0/1 192.168.1.100/24RouterB FE0/0 10.20.10.34/30 FE0/1 192.168.5.100/24I have a DHCP server hanging off RouterA FE0/1 with ip 192.168.1.153From RouterA I can ping ...
Hi EveryoneThank you so much for all your helpful posts.Just to let you know that I did use the traceroute tool to see where the packet was dropped, but after I used this I thought about posting the question.Regarding the traceroute I went to geektoo...
Hi I am not sure if PBR will work as the WAN is on a /30 IP Range?Another thought, can I build IP-IP tunnels between the sites and route these tunnels to the main site?
I think I have solved my DHCP Problem. I have added the ip helper-address command but on the LAN interface at the remote site. THe WAN interface receives the dhcp broadcasts, so when I changed that it all worked Thanks for the replies.Cheerswvw
Hi RajeshI think I found the problem. This is related to the dhcp not being "allowed through" What I would like to know is whether the router allows DHCP through automatically or not? If it does not allow it through how do I need to configure the rou...
