Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,When configuring an ASR1001 with ZBPFW, and when using a class class-default / drop log, for an OUTSIDE_TO_SELF zone (basically the outside interface ip address), I do not see the drop action log for any dropped packets, but the drop counter i...
Hi All. I have an ASR1001 where each interface in part of a VRF for services segregation. When implementing a ZBPF policy, specifically a Parameter-map type, i noticed there can be a number of inspect flavours. type inspect / inspect-global / ins...
Hi All,I have an ASA which terminates IPSEC VPN’s from both internal/private networks and from Public/3rd Party networks at the Edge.Can an ASA5500x running IOS9.3.x register (trust points / enrolments) with multiple CA’s ? (Private and Public)For ...
Xander,Hi.Good document, but have an issue. When i perfom the boot tftp using the asr9k-mini-p.vm-4.x.x file (which was included in the tar) the file is downloaded to the device and starts to boot.Even shows the new version. RSP0 reports MBI (Startin...
Xander,Hi.Actually, reading this, is exactly what I need to do. Downgrade to 4.0.x(p) from 5.1.x(px). The install activate fails because of the PX platform. Any ideas on how to return this back to the P platform. Thanks. Chris.
Agree, with previous post. Swop 61 & 62 lan / wan direction at one of the remote sites.Also note that only tcp flows are used. methods are either LZ / TFO / DRE or accelerated. See config manual appendix for list of protocols & method applied. Some ...
