Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I would like to know how to automatically have correct bandwidth under my Dialer Interface who is attached to an ATM Interface.Command bandwidth inherit doesn't work.=>interface ATM0 no ip address no ip route-cache cef no ip route-cache no atm ilm...
Hello,I have a problem with this simple architecture, I have 2 877 Adsl router connected to internet, each one with his own internet static IP adress.I made an HSRP group with this 2 routers.I need to made an Http server joinable from Internet, so I ...
Hello,As I say in the title, is there somebody who knows how to avoid losing first packet when IPSec tunnel goes up ???Like a dialer queue for example or something like that !!!Thanks
Hello,I try to implement CAR for limiting bandwidth used by specific trafic under an IPSec Tunnel between 2 878 routers over SDSL.I specify access-list and use the rate-limit command under the dialer 1 interface.The problem is that the dialer 1 inte...
Hi,Could someone give me the difference between isakmp keepalive and isakmp invalid-spi-recovery.In which case keepalive must be used and in which case invalid-spi-recovery must be used ?Which one is the best to maintain accurate ipsec vpn ?May I use...
Sorry but VA inherit everything but queueing strategy, I've got Dialer 1 with Class-based queueing and VA2 with fifo queueing ?At least, my question is : is there a command to have bandwidth under dialer1 automatically equal to atm bandwidth ???
Yes, interface virtual access 2 got the right bandwidth.But I have CBWFQ applied under dialer 1 interface so I need to have the right bandwidth for this interface for CBWFQ !
