Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About tproeber
Stats
Member since
06-26-2003
37
Posts
0
Helpful
0
Solutions
10-02-2014
I have the same problem with a new 3850. The Port-Based DHCP worked on a
3750, but after transferrin...
Created by
tproeber
in Network Management
12-23-2013
12-23-2013
I want to have routers tell each other how busy their links are. Whats
the best method to pass infor...
12-03-2013
OK, the end result is good and all the attached radios are shown in the
Sho-Run and the interface ba...
Created by
tproeber
in Network Management
11-27-2013
11-27-2013
Let's say I'm doing processing for 5 things that are semi-related, or
the same process but for many ...
Created by
tproeber
in Network Management
11-27-2013
11-27-2013
This may not be the place for this specific question . . . Regarding
writing the actual TX and RX ra...
Created by
tproeber
in Network Management
11-26-2013
11-26-2013
Yes, it was just the last "#". I think I'm on my way now.Thanks!Tim
Created by
tproeber
in Network Management
11-26-2013
11-26-2013
The Applet works but gets an error after successfully working:event
manager environment 900_TX 240ev...
Created by
tproeber
in Network Management
11-26-2013
11-26-2013
Sorry, I see the txrate is the var.Tim
Created by
tproeber
in Network Management
11-26-2013
11-26-2013
Thanks! I'm zeroing in on the solution!Is the "match txrate" part of the
command --or a note by you?
Created by
tproeber
in Network Management
11-26-2013
11-26-2013
The 900MhzTX Environment Variable is not getting set. I'm trying to
constantly display the radio dat...
Created by
tproeber
in Network Management
11-22-2013
11-22-2013
When I am SSHed into a radio and execute the mca-status, the output is
very long and is truncated.ac...
Created by
tproeber
in Network Management
11-22-2013
11-22-2013
Here I SSH into a radio and do the "mca-status" command. It has a long
output that gets truncated bf...
Created by
tproeber
in Network Management
11-21-2013
11-21-2013
I can SSH to the radio!Now I need to extract the TX ands RX rates and
range -- is this how I would d...
Created by
tproeber
in Network Management
11-21-2013
11-21-2013
Found it -- I had to escape the $ sign in the
password.Progress!Thanks,Tim
Public Statistics
| Date Registered | 06-26-2003 06:52 AM |
| Date Last Visited | 08-09-2019 12:01 AM |
| Total Messages Posted | 37 |
