Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi to all Yesterday i found on my 9300 output drops, using Cisco CLI Analyzer tool, i found that is due to Glean Adjacency interface with drops is connected directly to our fw with internet access, changed cables and both interfaces have same speed 1...
Hi communityJust a minutes ago happens to me a problem with a configuration between a HP an Catalyst9300between both switchs there are a trunk/etherchannel that configuration was working without problems since april, also was the same used with our o...
Dear All I have a ASA (9.1) where users can Access to internet, default Gateway is a L3 catalyst, behind that catalyst and i have another router and i need to give internet Access to them also, ping is ok from their network but they can´t Access to ...
Hi to everyoneFirst of all my apologies for my poor english, spanish is my first languageI have saw many posts regarding this but after read most of them none can solve my problemI have the following topology, WCCP is configurated on ASA, inside int...
hi to everyone, i am checking another posts with the same question and use almost the same configurations I am testing limit bandwith using my ASA 8.2,i am trying to limit internet access for certains users , i order to save Bandwith for the importan...
Thanks it was very useful, but i don`t know was happen but when i am execute this command on interface that have dropsi got this error, i can`t find anything about it #show platform hardware fed switch active qos queue config interface gigabitEtherne...
HI Catalyst 9300 is running pvst, Comware is using mst.., as far i know pvst is available on HP but i mst is compatible with pvst, root for all is the CatalystI been running same configuration with previous catalyst 3750 during 5 years without a simi...
i am pretty sure that all upgrade process will be ok, but how about the roll back process just in case of something goes wrongIn documentation i have not seen nothing about that, or is the downgrade process that should i use ? thanks in advance
I had reviewed on HP site about some similar issue, and found nothing, Comware switchs had not enough information about Cisco compatibility, just configurations and looks equals as mine.We have decide to upgrade firmware on both devices first 9300s...
