Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I exeprienced a reload problem in standby WLC, with HA in release 7.6.100.0.I use a dedicated VLAN to transport the redundancy sync and all the HA info, 'cause the two WLCs are in different buildings.The WLCs are 5508 model and they have same sw r...
Hi all,did anyone experience the LDAP integration between Open LDAP 2.4 and CUCM 8.5 or other CUCMs (6 or later)?I have a CUCM 8.5 and it fails in importing users from ldap DB. I verified the search base and the ldap account with ldap browser and eve...
Our customer has a CUCM 7.1.5 and he has the need to dial short numbers beginning with "*" ( i.e. *XXX or *115 ...) from an analog phone connected to the ATA.With ATA 186 everything worked fine with these audio parameter on ATA 186 (SCCP): Audio Mode...
I'd like to add a prefix digit "0" to the ext phone numbers of the corporate contacts, imported from LDAP in CUP 7.0.2 (operating with CUPS 7.0.6 and CUCM 6.1.2). The "0" prefix is used to route the calls towards the PSTN. The application dial rules ...
Hi,I exeprienced a reload problem in standby WLC, with HA in release 7.6.100.0.I use a dedicated VLAN to transport the redundancy sync and info, 'cause the two WLCs are in different buildings.The standby WLC reload continuously 'cause it doesn,t fin...
Hi Rishi,almost all the IP Phone Cisco 79XX or 69XX use the rule *XXX, so the exception you proposed (it should be only for analog phones connected to ata187) is not allowed by the customer.Regards,Federico.
Hi Chris,I ask your questions below:-Are you receiving any error messages? NO-Can you confirm that the Cisco DirSync process is started and/or reset and try the sync again. YES, I tried.-Also, you may want to check to make sure there are no firewa...
Hi, the star key problem is not solved yet, 'cause the "*" is used to program the ATA187.I can tell you the ATA187 works quite good with faxes and analog calls using the last firmware version.The tricks are (under ATA device in cucm config): 1) 600 ...
