Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need help with using IP SLA to route traffic to backup ISP when primary is down and revert back to primary when it comes back up. We have two buildings each containing a core switch (3850) and a FTD firewall connected to a different ISP. Each cor...
I have gone through posts on the forum for allowing VPN access to a DMZ host but I am missing something and hoping another set of fresh eyes will spot the issue. Basically, need a VPN profile to allow vendor to access one host in the DMZ. The VPN w...
We have a pair of ASA 5585X firewalls that need to connect to a pair of Avaya VSP9000 switches. The Cisco docs refer to doing spanned etherchannel with a Cat 6500 switch using VSS or a Nexus switch using VPC. Does spanned etherchannel work with non...
I have a site where an ISP installed ethernet over copper and they have provided a WAN address w /30 mask (e.g. X.X.X.2/32) and 8 public LAN addresses (e.g. Y.Y.Y.1/28). There is an ASA5505 installed with the outside interface currently using the WA...
Please help... went through the VPN wizard. Can establish a connection but can't access anything on the inside interface. Is there an access list rule that is missing or a sysopt connection statement that is needed?I've attached the current config....
I tried that before and the "set interface null0" generates the following error in the log and I'm unable to apply the route-map policy to the VLAN interface. The above command is valid for configuring the route-map though. %FMANRP_PBR-3-UNSUPPORT...
