I have a pair of Nexus9000 93180YC-EX configure with vPC and each Nexus 9k is connected to a Nexus 2k
I notice my interface port channel is in (suspended(no LACP PDUs))
SW-1# show lacp interface eth1/1Interface Ethernet1/1 is suspended Channel grou...
I am trying to rollout 802.1x on WS-C2960S-48TS-LCisco IOS Software, C2960S Software (C2960S-UNIVERSALK9-M), Version 12.2(55)SE5, RELEASE SOFTWARE (fc1)
Why am I getting the Status 'Drop' below?
SW#show mac address-table interface g1/0/24 ...
I need to use NAT on R1 to allow users from 192.168.26.0/24 access to 172.16.26.0/24.
Can NAT be done to translate users from 192.168.26.0/24 to 172.16.26.0/24 via R1 loopback interface ip 3.3.3.3 or any other alternative? Thanks in advance.
I have a requirement as shown in the diagram. When R1ping to loopback0 on R2 and R3 will reply to the ping.
I am not allow to change the ip nat inside (on Fa0/0) and ip nat outside (on Fa1/0) on R2. Thanks in advanced.
Hi,Need help as I could not launch the ASDM via https://192.168.0.254 So far I am only managed to ssh. Thanks in advanced!Cisco Adaptive Security Appliance Software Version 9.0(2)Device Manager Version 6.4(5)ASA-FW# show run | in httpaaa authenticati...
R2 ping to 3.3.3.3 source 192.168.26.1 works when NAT is remove.
ip nat inside source static network 172.16.26.0 192.168.26.0 /24
There are routes for R1 to ping to 192.168.26.1 and 172.16.26.4
R1#show ip routeCodes: C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, ...
R1#sh run | in ip routeip route 172.16.26.0 255.255.255.0 1.1.1.2ip route 192.168.26.0 255.255.255.0 2.2.2.1
R2#sh run | in ip routeip route 0.0.0.0 0.0.0.0 2.2.2.2ip route 3.3.3.3 255.255.255.255 2.2.2.2
R3#sh run | in ip routeip route 0.0.0.0 0.0.0...