Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I'm a noob so please don't mind any eventual mistakes What is the correct way to set up this:1. Only Computer A should be able to access Computer B. Computer A can also access anything that it demands.2. Computer B should access ONLY Computer...
Hello guys,I'm pretty much a noob in networking so I'll try to lay out my problem as plainly as possible.I have two Catalyst 2960 Series (48 port) switches with the newest Cisco IOS installed. There is also a Cisco 2600 Series Router which I can't ma...
Greetings,Here I have a network of two Cisco switches (Cisco Catalyst 2960) connected together to a router which I am not managing.They're also connected to each other. All the wifi AP-s are connected to the second switch while everything other on th...
Hi guys,thanks for the replies.I tried the IP ACL and they did work but weren't completely satisfactory in a sense that my device is still available on pure layer 2 (network scanner could easily find it) so I just added the following to the end of my...
Hi blau grana, thanks for your reply.I tried your suggestion and it didn't work. It blocked ALL the traffic directed towards and from PC B.After applied I couldn't access the PC B from any computer. I double checked the MAC address so I'm certain I g...
