Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For example I have a border router with two ports, first port is wan port and another port is lan port. How many VLANs possible to assign to a router port?
Today on a site I have found the opinion:"Loopback interfaces are logical and maintained within software and *NEVER* go down as long as the router is turned on and operating (unless you "no" them). Anyone who uses a subinterface as a loopback inte...
I want to connect my clients from the Windows WS to a VPN Tunnel using 3925 router w/o Cisco VPN client. Is there the way to use native IPSec client on Windows XP or Windows 7?
Hi, All!While booting Cisco I see three warning messages.What have to do to resole it?=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2012.04.11 20:38:38 =~=~=~=~=~=~=~=~=~=~=~=c3925#reloadProceed with reload? [confirm]Apr 11 14:42:46: %SYS-5-RELOAD: Reload reques...
I have config like that, for Cisco router:interface GigabiteEthernet0/0.2 encapsulation dot1Q 2 ip address 192.168.2.2 255.255.255.0interface GigabiteEthernet0/1.2 encapsulation dot1Q 2 native ip address 192.168.1.1 255.255.255.0ip 0.0.0.0 0.0.0.0 19...
Hi Inayath,I saw a design of network like belowISP <--> [fastethernet0/1]SWITCH1[fastethernet0/2]<--> ROUTER<--> SWITCH2When I asked about the SWITCH1 purpose on the scheme I was told the purpose of the SWITCH1 to terminate VLANs.So why I asked that...
1. add vlan, for example with id 2.2. add ip address in vlan 2.3. port which connected to your computer must be vlan 2 native mode acces, all trafic trought out from this port will untaged.use command switchport mode accessorencapsulation dot1q 2 nat...
1. Find out port com number in device meneger. There must'n be conflicting devices by IRQ. Use some port in putty.2. Hit enter key twice. You will see promt.3. Check your config. This port don't have to be disable. Enable by default.
