Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In my DMVPN network, assuming I have 2 spokes A and B both are advertising the same prefix 10.1.1.0/24. In case, if spoke C want to access 10.1.1.0/24, how will NHRP decide which spoke should it build dynamic tunnel with, A or B? I assume NHRP will c...
We encountered this wired high cpu case with the 2960x stacking switch, which is caused by logger. Does anyone knows what does this means? #sh proc cpu sorted 5secCPU utilization for five seconds: 99%/0%; one minute: 98%; five minutes: 91%PID Runtim...
Currently I have setup one pair of Cat6 with VSS enabled. And this VSS is connected to 2 core routers with MEC, which means each Ca6 has 2 links to the 2 core routers respectively. BGP is the routing protocol that been used between them and graceful ...
Actually I also thought PBR. But PBR has limitations, like if spoke A is down, how the traffic can swing to spoke B? And in case, there are 2 routers for spoke A and 2 routers for spoke B how can PBR point to 2 routers?
The real setup is in each place, we have 2 routers for redundancy. there is a very complex story behind of both A and B are advertising the same subnet. What I want to know is, whether there is the way to manually set what NHRP redirect message the h...
