Ok, I recently upgrade my two production UCS system to 2.1.2a and now I'm gettting this F1237 error, (voltage threshold cross) on two of my servers blades. There doesn't seem to be much info on this error ... anyone have some insight?Thanks,Cy. ...
Ok .. I'm confused ... I'm getting random resets on my IOM modules ... it's always the x/2 IOM that reset and and becomes inaccessible. What can cause this?
hi all,I see this error affecting my M72KR-E adapters. I can reset connectivity with the DCE to clear this error, but it just keeps coming back. I'm on 2.0(1x) right now ... and my M71JR-E.Q adapters don't get this error.Any thoughts?Thanks,Cy. ...
Hi all,I was wondering on how do I go about getting my link on IO Module backplane.My set up as follows ..7 B200 server and 1 B440 server in a chassis. All of my backplane ports are online except for 1 of the B440 ports. It just has a link down. N...
Sorry, meant to say 6 b200s .. .and yes my b440 has the two mezz cards in them. I have two adapters in my b440.I have two chassis with b440s on it them .... on the second chassis, only 1 port down on the fabric, fabric a .. fabric b is good to go ....
Ok ... I am completely baffled now. My current UCS system consist of 5 chassis and the FI 6140. My upstream switch is a Nexus 5548. I have tried three different versions on this UCS - 1.4.1m, 1.4.3q and 2.03q. I have installed the cisco build 260...
Hi Robert,At this point, I have the ESXi on vlan x .... and the service profile vnics only has the default vlan (1) attached to it. From subnet y, I can ping the ESXi host and the ESXi host can ping a workstation on subnet Y.Where do I find the veth ...