Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have an exchange environment that consists of four cas servers. I have a load balancer in place which I nat to one public IP address.The problem is when my cas servers send email it doesn't show as the same ip as the one for the load bala...
I'm having an issue with getting traffic to pass through a encrypted vpn tunnel when a server has been configured for NAT for external access. I'm using a Cisco 861w running version 12.4(22r).I understand that I need to configure the NAT a different ...
I'm having an issue with getting taffic between the two routers to work. Below is my devices:Main Location:Cisco 861w (static IP)10.0.0.0 / 255.255.255.0Remote Office:Cisco Small Business WRVS4400N (dynamic IP)192.168.2.0 / 255.255.255.0At the main l...
Sorry if this is the wrong forum but I didn't see one related to hardware upgrades.I have two ASA 5510 running verion 8.0(5) with 256MB of RAM. I need to upgrade it and was going to go ahead and upgrade to ASA5510-MEM-1GB. I see that with version 8.2...
Hey there!I have a working environment but wondering if there is just a better way to accomplish what I am trying to do (without a layer 3 or 4 switch). Basically I have a few sub interfaces on my Cisco ASA5510.Now what I do need is some of the VLANs...
I can do that when I get to the office this morning. I tried with this mobile app but it didn't mark it as the answer. Maybe a bug or somethingSent from Cisco Technical Support iPhone App
I got it working. I added a static nat rule for the incoming and a static dynamic nat for the outgoing like you we're sayingThanks for your help!Sent from Cisco Technical Support iPhone App
Ok I think I might have got it to work.I created the global pool for 1.2.3.4.Then I created a static nat for 10.1.11.1 3389 1.2.3.4 3389Then for the other server (ones that don't have any outside to inside traffic) using a dynamic NAT rule for 10.1.0...
To use a global pool I have to use a dynamic policy. When I do that it does seem to work. I tested it on a couple servers and they do go out on that ip (both of them), but the problem is allowing external access on that IP to go to a specfic server.S...
