Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,got a question wrt the bandwidth requirements of the former Tandberg TP endpoints: why do the Cisco datasheets always state "up to 6 Mbps point-to-point", while you really only need 2,5Mbps for 1080p30 ? thanks,Bart
Hello,has someone else experienced the same "issue" as described below ? And can someone (Cisco ?) tell whether this is by design, and if so, what the reasoning is behind this ?We use virtual telnet for user authentication, when users need to pass t...
Hello all,I got a problem with a PIX515E, Cisco PIX Firewall Version 6.3(1)Cisco PIX Device Manager Version 3.0(1):there are 3 networks involved: outside, DMZ, net3- security levels: outside=0, DMZ=60, net3=80- from both outside and DMZ, I need to go...
Thanks for your replies.- While dual stream will add some BW for sure, it won't go up to 6Mbps, or will it. How much would it typically need BTW ?- Multipoint would add indeed a bunch of BW, but the "up to 6Mbps" is also stated for endpoints that do...
Tomonori,can you make any recommendations as to router models that support the required size of buffer size/packets per second ? Related to that: is it correct to say that virtually any - recent - Cisco switch model is supported for CTS connectivity...
Well, I was checking the same thing, and to refer back to the CCO link referred to above, actually in the question before the one quoted above, Cisco is saying upgrading a CTS-1100 to a CTS-1300 IS possible ..... ?!Q. What are the primary differences...
