Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, I am having a bit of trouble setting up an SG300-28P set for L3 and DHCP. I will attach a basic network diagram and a very short list of my needs.I am building a temporary network for a 1 day company event that I cannot get working in...
Hi,I am looking to enable the internal DHCP on my WLC. I have enabled it and it seems to be operating correctly but I think my routing and or settings allowing me to access anything beyond the private network is wrong.DHCP is handing out correct IP i...
Hey cchamorr,Look like I will be be purchasing a router after all. I managed to get it all working in a test environment using a $100 cisco WAP with NAT built it. I unfortunately need something with an SFP connection. Do you have any suggestion for ...
Moorthy, I have everything working except for access to the internet. I believe I need another router to go between the IP given to me and the L3 switch as it does not perform NAT as mentioned by cchamor. -R
Hey,I will need more than 300+ IP's and the 10.2.2.20 network they gave me to use is only a /24No option to put a routing statement on the SG300 to point all traffic from VLAN 100 out using VLAN 101 (10.2.2.20) ?
Hi,1. Correct, Switch is on Layer 32. firmware 1.4.0.88 bootcode is 1.3.5.063. I currently have Vlan 1 set to the default 192.168.1.254 (I tried making VLAN 101 with IP 10.2.2.20 the Uplink port)4. VLAN 100 currently has an IP of 172.16.0.1 ( I just...
Hi, I was given an address of 10.2.2.20 from the company we are renting the space from. It is basically just an ethernet connection off of their existing network. Currently I have Vlan100 with the IP address of 10.2.2.20 (the IP they gave me) plugge...
