Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just updated a couple of 5545s this morning. Everything appears to be fine with one minor exception; we can see that traffic on the Cluster Control link is now sitting at a steady 140MBps and CPU is at a steady 30%. There is very little traffi...
Can't seem to find my previous reference to upgrading clustered ASAs in master/slave config. Can someone please verify if the following looks correct? Also... does the nomenclature change from Master/Slave to something else when going from 9.2 to 9...
Got an interesting one here. We have three flavors of Cradlepoint router. The early 1200, the 1200b and the 1400. I am setting up peer tp peer VPNs. The Cradlepoints sit in a school bus and connect to the ASA in our district office.The ASA 5510 i...
Our wireless infrastructure is comprised of about 50 cisco 1131 LWAPs and two controllers... a 4402, and a 5508.Our primary SSID is published, WPA + WPA2, Auth(PSK)For the most part, we have no issues whatsoever with any of our workstations connectin...
Our ISP is delivering our traffic on a single metro ethernet link. This comes directly into G0/1 on our 3560G. G0/1 is a trunk port and allows vlans 202,210 and 285.As part of a QnQ experiment, they are sending vlan 285 as a dot1q tunnel. So G0/1 ...
Well... I'm officially baffled. After a full day of normal traffic (600Mbps 5 minute average) the traffic on the CCL remained high, but now that people are headed home and traffic is down to a trickle, the CCL traffic has backed all the way down n...
Thank you for the response Milos. We went to 9.12.1 at the recommendation of the TAC earlier in the year. I originally bumped up to the latest version and ran into a configuration error that was preventing the data unit to join the cluster. This ...
Hi Rob...We bumped up to 9.12(1)3We saw this issue about a year ago and the problem just went away. I find it odd that it started up again right after the upgrade and reboot. The process also moved the ASA that was Master all this time to Slave. ...
