Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have a IPSec VPN between remote site (Kuwait- uses Cisco ASA) with HQ (Mumbai- Uses Checkpoint).
Both the Public IP peers reachable to them with 80ms however as soon as we create the IPSec VPN tunnel and introduced the respective LAN IP's , th...
Hello All,In My organization scenario, we are using Autonomous AP's. Every floor has couple of them installed to cover the network of an entire floor.Now company purchased one WLC 5508 and Light weight AP's.I have assigned this project to remove one ...
Hi AllI have two Switches which i need to put in a same stack - WS-C3750E-48TD and WS-C3750G-48TS . Kindly suggest if can do so and also which IOS to put in both the switches as WS-C3750G-48TS is having lower RAM and flash.Whether can i put following...
I think, Its just a mode of representation. with wild cart or subnet mask.
router will send update (about subnet mask) as it is from live connected interface or from neighbour's update
Hi Scott, Thanks for the reply. Please find the below snapshot of the WLAN Layer 2 and SH WLAN from CLI of WLC. Concern here is I want my users to connect it to the WLC on WPA/TKIP which is not happening. I can see Machine is trying to connect to WLC...
Hi LeoThanks for the suggesion!.that means as per ur suggesion my switch -- a. WS-C3750E-48TD will have IOS -- c3750e-ipbasek9-mz.122-55.SE7.bin &b. WS-C3750G-48TS will have IOS -- c3750-ipbasek9-mz.122-55.SE7.bin then this both can be in the sam...
Thanks a lot Bilal Nawaz!I have checked that WS-C3750G-48TS switch in my case is having flash of 32 MB. So by your suggession i can upload the two IOS (which i mentioned in my earlier post) in both the switches and can connect them on the single sta...