Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI'm trying to configure a Cisco 2821 (Version 12.4(24)T IPBASE) with Multi-VRF and Policy Based Routing.It seems that the PBR with Multiple Tracking Option is not supported into this release.So it's not possible to configure ip sla monitor featu...
HelloI receive from DFM a Duplicate IP address alarm from 2 differents devices (router1 &2).I have removed from router2 the duplicate IP address (it was on a shutdown interface) but DFM continue to send alarm from both devices (router1 &2).I have res...
helloAfter I suspend a device component (ex. Interface of a router), does it possible to see a list of devices with suspended component?I like to remove recurrents low priority alarms. Best RegardsAndrea
HelloI have a LMS 2.6 installation with RME 4.0.5. All works fine except that after 1-2 weeks without problems, the web page http://ciscoworks:1741/rme/RMEHome.dodon't appear (page timeout).All the RME services are runningCS, DFM, CM pages appears co...
HelloIt's possible to forward the results of all RME jobs to an predefined email address? (different from the email address defined from the job owner)?For example: the administrator like to known all the Jobs applied from differents networks enginee...
See the following messages from ANI.logI have a 1500 LMS LicenseTime base VMPSMajor has 6 major nodes and 3 minor traversals._startTime 2009/10/22 10:00:002009/10/22 10:00:00 VMPSMajor ani MESSAGE DBConnection: Created new Database connection [hashCo...
HelloI have exactly the same problem.After upgrade 3.1 > 3.2 the Data Collection don't works.No problems with the daily UT AcquisitionI have checked the ani.log and I found a lot of "Validating License..." messages
after suggest of TAC I reinitialized the perl dbRestoreOrig.pl dsn=dfmEpm dmprefix=EPM perl dbRestoreOrig.pl dsn=dfmInv dmprefix=INV perl dbRestoreOrig.pl dsn=dfmFh dmprefix=FHBut at this moment I haven't resolved the problembyeandrea
HelloI have do so, but when I restart the LMS (for other raisons) the alarm come out again...and I have to clear another time...No way to remove completly the alarm?ByeAndrea
