Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a very basic greeting and What I want to do is play the record, if caller knows to whom he calls and click the internal number, then forward the calls. If nothing is pressed by caller, then forward it to secretery. When I try this, it pla...
Hello everyone,I'm a newbie in wireless section and have a problem. I have two autonomous AIR-LAP1041N-E-K9 with IOS "c1140-k9w7-mx.124-25d.JA1" and one 2504 WLC. I need to convert those APs to Lightweight and use with that controller. But, I don't h...
We have configured a ESA for a customer whose appliance was broken down because of a software problem and being replaced with a new one by cisco. Today we have a big problem about Reverse DNS. When they send email to their customers, the remote mail ...
Hi,We have set up ironport C170 email appliance to a customer. Everything seems fine until morning. They called me and said a single e-mail account (gmail) have sent 60 mails to a client instantaneously and all of them passed through ironport. So how...
Hi,We have a problem with our ironport C160 product. When we power on the device, it is starting its services and replies pings you can see from (1). After that, it doesn’t ping no more and web page couldn’t open. For testing this issue, I connected ...
Thanks lindborg. I applied "times to reprompt the caller" to 1 but it plays recording after and after. What I want is play the record two times and if there is no action by caller then forward it to operator number(secretary). Is there anything to be...
Hi Scott,I can easily connect AP to WLC and ping each other, there is not any issue. But when I connect the laptop to another port, WLC wants to give that port an ip address from a different subnet. I just didn't figure out how I will configure WLC p...
Thanks for the response. The problem should be originated from wrong PTR record I think and I told that to the customer. There isn't any configuration change in both ESAs but nat was made by customer newly.
Hello Bob,Thanks for the reply. I guess I understand the problem but don't know how to solve it. After some analysis in the message tracking ı found that source IP of the mails seems the default gateway of ironport. Actually, I was shocked. How can i...
Hi Donny,A couple of people have said ironport needs RMA. But, fortunately the appliance has started to work. Now, It operates like nothing happened interestingly.Thank you,Mehmet.
