Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I am trying to set up a 2960 that is on vlan 20, as all machines get an IP for that vlan but also allow all other vlans to connect to it. Below is the configuration I have for the uplink and all computers plugged into the interfaces. As of r...
Hi All,I need to add a new vlan to my 1841 and as of now the two vlans I have are essentially tied to the two interfaces on the device. Is there a way I can add another vlan with out having it tied to an interface as there are no more? Below is the...
Hello,I am not sure if this is by design or not but I have dhcp running on my 1841 basically with a 192.168.1.1 - 192.168.1.255 pool. While I do have set excluded ranges I find that the system does not look for any open IP's once it reaches that las...
Hello,I have an 1841 and started to run into an issue which can be resolved but looking to see what you guys prefer to do in this situation. We allow users to connect the laptop via ethernet and wireless to our network at the same time as well as an...
I have a 1250 setup and working perfect. The company now wants to allow a guest network and from what I gather the owner has an Apple airport which has a simple check box that can be enabled so guests can log on with just access to the internet. Wh...
Correct this is what I have and works fine. interface GigabitEthernet0/1-23 switchport access vlan 20interface GigabitEthernet0/24 switchport trunk native vlan 20 switchport mode trunkswitchport trunk allowed vlan 1,2,5,10,20 -> This is by default n...
Maybe this will help you help me BackboneServerSwitch#sh int trunkPort Mode Encapsulation Status Native vlanGi0/24 on 802.1q trunking 20Port Vlans allowed on trunkGi0/24 1-4094Por...
I tried that and was not able to pull from the dhcp server. I have essentally removed all configs for the ports to start over again. What should the upling port, port 24, have? What should all the other ports have? OR configured...?
That is correct and what I thought but I want to confirm the programming side. Can you confirm this is correct for me?interface GigabitEthernet 0/1-0/23 - Blank no configsinterface GigabitEthernet0/24 switchport trunk native vlan 20!interface Vlan1 ...
Maybe I should word my question differently so my appologies on the confusion. I want to make sure all packets for a computer are untaged but the uplink port should be tagged correct? If that is true and int 24 is the uplink then this would be corr...
